GSK928TC system: Statement form: G32Z (W)----P (E)-----L; Among them: Z (W) -- the terminal coordinate that attacks a tooth or the length that attack a tooth. P -- , the pitch of metric whorl. E -- , the pitch of imperial whorl. L -- , the head number of whorl. The executive process that G32Z axis attacks a tooth to circulate (1) Z axis feed attacks a tooth. (2) close main shaft. (3) await main shaft dead stop. (4) main shaft inverts. (5) Z axis retreats a knife. (6) main shaft stops. Exemple: The N0010M3 of only head whorl of whorl lead 2MM; (the main shaft that start) N0020G32Z-40P2; (the loop that attack a tooth) N0030M3; (restart main shaft) N0040G0Z100X30; (continue to machine) note 1: Attack what the basis answers to be able to attack a tooth before the tooth to come back to direction of rotation of affirmatory main shaft, the main shaft after the end that attack a tooth will stop roll. If need,continue to machine should start main shaft afresh according to need. Note 2: Because this instruction is tigidity to attack a tooth, after main shaft break alarm is effective main shaft still will have proper slowdown time. Right now Z axis still follows the drive of main shaft, till main shaft dead stop. Because this is actual what the bottom outlet that machines whorl should compare real need is a bit a few deeper, discretion of rotate speed of the main shaft when specific length basis attacks a tooth and whether have unit of main shaft brake and decide. Be no good with tapper? Several cars attack a tooth to need special tap clamping apparatus, get on tap outfit in tool carrier namely. CNC MillingCNC Machining